Raxiom Axial Series LED Reverse Light with Running Light and Triple Flash Brake Light; Smoked (15-17 Mustang)

Great quality product! Requires a little bit of wiring but it’s very straight forward. Very happy with how it looks!

This reverse light adds an extra pop to the back of your mustang. The LED lights are very clear and very bright. The pulsing brake light is a nice added touch as well. The video on here said it would take about 30 min to install, it took me about 2.5 hours. I was not able to lift the car. I think because of the tight confines, accessing the top two screws on the light did cause me some difficulty. Taking out and putting the top screws back in on the light is where most of my time was spent. The video on here says use a screwdriver(they installed on a ‘15, mine is a ‘17)I needed to use a ratchet with an extender. A screwdriver with a socket end may work best. The scotch locks to connect the wires were fantastic. Not having to cut and splice wires was one of the reasons I bought this to install myself. Overall, a relatively easy install other than accessing the top screws on the light.

Quality easy to do triple flash brake light is great. Highly suggest and very bright. I thought i got a defective one but i just didn’t splice it hard enough so make sure you do that! Easy install and if you have a stock subwoofer in premium models it’s only 2 bolts to take off and get that out (tons of YT vids)

Super happy with the upgrade to the reverse light and third brake light. LED's are the way to go in general over the factory halogen bulbs, but between the addition of the third brake light (w/ the triple flash), along the fact the whole unit is a smoked lens, and LED's It's utterly perfect! Installation wise, fairly simple, if you don't have a lift where you can get the vehicle up high enough, you may want to just remove the rear bumper (Certainly do not HAVE to do this, but I also swapped the factory rear reflectors to an LED, so having the rear bumper off just made EVERYTHING so much easier!) Just as the video describes is as simple as 4 bolts, and running a wire up to the taillights and splicing them into the factory harness for the brake light with the supplied T-Taps. SUPER EASY to do, and AMAZING results!

Good quality I myself had someone install they keep my car for 2 hours but I was also have amplifier install for my system so couldn’t give good install time but product looked good and working fine I love the new look it gives my mustang